In a four stage compressor, if the pressure at the first and third stage are 1 bar and 16 bar, then the delivery pressure at the fourth stage will be

1 bar

16 bar

64 bar

256 bar

IIT EntranceIIT-JEE

Write a comment

If p1, is the pressure of air entering the L.P. cylinder and p2 is the pressure of air leaving the L.P. cylinder (or intercooler pressure), then the ratio of cylinder diameters for a single acting, two stage reciprocating air compressor with complete intercooling is given by (where D1 = Dia. of L.P. cylinder, and D2 = Dia. of H.P. cylinder)
Attempt Now
When the temperature of air leaving the intercooler, in a two stage compression with intercooler, is __________ the original atmospheric air temperature, then the intercooling is known as perfect or complete intercooling.
Attempt Now
The two links OA and OB are connected by a pin joint at O. If the link OA turns with angular velocity ω1 rad/s in the clockwise direction and the link OB turns with angular velocity ω2 rad/s in the clockwise direction, then the rubbing velocity at the pin joint O is (where r = Radius of the pin at O)
Attempt Now
Assertion (A): The steady state response, of a stable, linear, time invariant system, to sinusoidal input depends on initial conditions.

Reason (R): Frequency response, in steady state, is obtained by replacing s in the transfer function by jω
Attempt Now
The velocity ratio in case of an inclined plane inclined at angle θ to the horizontal and weight being pulled up the inclined plane by vertical effort is
Attempt Now
In diesel engines, the fuel is injected in the form of very fine spray, into the engine cylinder, which gets ignited due to high temperature of the compressed air.
Attempt Now
When two main plates are kept in alignment butting each other and riveted with cover plate on both sides of the main plates with two rows of rivets in each main plate, the joint is known as __________ double cover butt joint.
Attempt Now
Intercooling in compressors results in saving of power in compressing given volume of air to a given pressure.
Attempt Now
In a fuel injection system, the electronic control module (ECM) calculates the optimum fuel-injection volume for the engine condition based on the data received from the sensors, and injects this volume of fuel into the intake manifold at the optimum timing.
Attempt Now
The tractive force in a locomotive with two cylinders is given by (where c = Fraction of reciprocating parts per cylinder, m = Mass of reciprocating parts, ω = Angular speed of crank, r = Radius of crank, and θ = Angle of inclination of crank to the line of stroke)
Attempt Now